Brakes - 1950 Studebaker Champion

There is a good post on the SDC Forum detailing the steps required for a brake re-do on a 1950 Studebaker Champion. Here is an excerpt.

Steps required:

1) Dual master cylinder (from Turner)
2) Hone, rebuild or replace wheel cylinders
3) Install new brake lines
4) Install new brake shoes
5) Clean up brake drums
6) Install new brake hoses
7) Install new front drum grease seals
8) Clean, inspect (replace if required), repack inner/outer front wheel bearings
9) Pull rear axles; clean, inspect (replace if required), repack rear axle bearings
10) Install new rear axle inner and outer axle seals
11) Check axle endplay and reset if required
12) Inspect emergency brake cable, ensure it is free and in good condition, replace if needed, lubricate

See the full thread about this topic.